Call (636) 394-3331

SEE 3-D i® (industrial)

SEE 3-D I- INDUSTRIAL

The Small Bore Surface Replicator was developed to examine the surface finish in difficult-to-measure small bores. Small diameter parts with critical surface finish features can prove very difficult to measure with standard equipment. By leveraging technology used to create precise surface finishes on small bores, C-K Engineering has created a surface measurement system that can reach where no profilometer can.  A two-part silicon rubber compound is used to make a 3-dimensional negative copy of the bore surface, which then can be analyzed with a non-contact surface analyzer to provide all the vital surface finish data you need.  The Small Bore Surface Replicator will allow you to accept or reject parts on the basis of surface finish from anywhere along the bore, not just on the ends, or from estimates made with visual equipment.

Features & Advantages
  • Accurately reproduces cylinder bore surface finish and wear pattern
  • Minimal setup time
  • Provides 2-D, and 3-D data (RK, RPK, RVK, Ra -SK, SPK, SVK, Sa)
  • Fully integrated system
  • Wide range of bore diameters and lengths (any bore can be replicated)
  • Samples are storable indefinitely and available for analysis at any time
  • No fragile probe
  • Dispensing system creates little or no mess
     

3-D Image

 

2-D Image
Sizing Information
  • For bores between 0.370"-0.495" diameter and lengths of 3", 5", 8", and 9"
  • For bores between 0.495"-1.031" diameter and lengths of 4", 6", 9", and 10"
  • SIZING CHART
  • Other sizes are achievable within a 4 to 8 week leadtime
 

Histogram

 

Roughness Chart
 
Download SME Paper